one ton boiler Agent exit air velocity

Difference Between AFBC Boiler and CFBC Boiler AFBC ...

1. Velocity. AFBC= 1.2 m/sec to 3.7 m/sec CFBC= 3.7 m/sec to 9 m/sec. 2. Heat Transfer Surface. AFBC= Heat is extracted within the the bed CFBC= Heat transfer occur outside of combustion zone i-e Convection section water walls and at the exit of the riser. 3. Size of Coal. AFBC: 6-10 mm CFBC: 6- 12 mm. 4. Combustion Air Supply. AFBC: 3 - 5 psig CFBC: 1.5 - 2 psig

Learn More

Steam Calculators: Boiler Calculator

Mar 17 2015 · Steam Boiler and Blowdown Pressure are the same. Combustion Efficiency is the % of fuel energy that is directly added to the feedwater and not otherwise lost or used. Blowdown Rate is the % of incoming feedwater mass flow rate that leaves the boiler as a saturated liquid at boiler pressure.

Learn More

The application of pressure-jet burners to marine boilers ...

The air path was divided in three ways around the outside of the swirler through the air swirler and a small amount inside the cap plate over the atomizer. Data was obtained for two different spray angles 60 ~ and 80 ~ at the full power rating of the burner which was approximately 1 ton/hr.

Learn More

Problems on Thermodynamics part2 | hvac machinery

The velocity of air leaving the compressor is 100 m/s. Neglecting the velocity at the entry of the compressor determine the power required to drive the compressor if the mass flow rate is 15 kg/sec. Take Cp(air) = 1 kJ/kgK and assume that there is no heat transfer from the

Learn More

1926.57 - Ventilation. | Occupational Safety and Health ...

An adequate air replacement system is one which introduces replacement air upstream or above the object being sprayed and is so designed that the velocity of air in the booth cross section is not less than that specified in Table D-57.7 when measured upstream or above the object being sprayed.

Learn More